If a signature pad is attached to your workstation, you can sign right inside Aktenplatz with it. You grant access to the device once under Profile → Hardware; after that the PDF viewer takes the signature from the pad. Without a device you sign in the window – with mouse, finger or stylus.
No installation and no licence is needed: the browser talks to the device directly.
1. Grant access to the device once
Open your profile and choose Hardware on the left. In the top section, Signature device, click Connect device. The browser now asks whether Aktenplatz may see this device – that is the browser's own prompt. Pick the pad and confirm.
The device name is then shown with its state:
- connected and ready – all set.
- set up, but not connected – plug the device in; the page notices by itself.
The grant applies per computer and browser
The grant lives in the browser, not in your account. Move to another workstation, or use a different browser, and you set the device up again there. That is not sloppiness but the line the browser draws: a website may not see attached devices without explicit permission.
Which browser, which device
Browser: Chrome, Edge and Opera can talk to a signature device directly. Firefox and Safari cannot – there the section reads "Not possible in this browser", and you sign on screen instead.
Device: the Wacom STU-540 is supported at the moment. Any other model is refused, with the message that we do not know this model yet and a request to send us its name. We only add models whose dimensions are documented – guessed dimensions would produce a signature in the wrong place and at the wrong size.
2. Signing
Open the document in the PDF viewer. The toolbar holds a Signature button. It is always there, even when no device is connected.
A window opens with the name of the document at the top – so you can see what you are signing. If a granted pad is connected, it is opened straight away and the window says "Please sign on the pad." You sign on the device and the stroke appears in the window.
Without a device – or via Sign here in the window instead – you sign directly on the surface in the window, with mouse, finger or stylus.
For corrections there are Undo last stroke and Clear. The Use signature button stays disabled as long as there is nothing that could be a signature.
3. Placing the signature in the document
After Use signature the window closes and Aktenplatz waits for the spot: click the place in the document where the signature should go. The hint for this sits at the top of the viewer. Changed your mind? Cancel – the Signature button stays highlighted until then, so you can see where the mode comes from.
Disconnecting the device
In the Signature device section, click Disconnect. Some browsers cannot withdraw their own grant; Aktenplatz says so in that case and names the way: in the browser's site settings, under "Connection is secure".
When nothing arrives from the device
If the window says that nothing has arrived from the device yet, or that the device is sending but its packets yield no pen data, put the pen down on the pad once and lift it again. If that does not help:
- Open Technical details about the device at the bottom of the window and send us that line.
- Or click Record the device (for support), follow the two steps (hold the pen just above the pad, then draw a stroke), save the recording and send it to support. That lets us teach Aktenplatz the model.
In the meantime signing always works: in the window, without a device.
